AlertCast® Installation
- Confirm placement of concrete ramp is in full compliance with Federal, State, local standards, building codes, project plans and specifications prior to installation of alertcast panel. Refer to alertcast’s website for compliance documents www.alert-cast.com.
- Concrete physical characteristics shall be consistent with project specifications while maintaining a slump range of 4 – 7 inches to ensure a solid and stable base for the alertcast panel.
- Allow concrete to set up to a semi-solid-state prior to installing alertcast panels. Alertcast PENETRATOR TM anchors are specifically designed to enable ease of installation while providing enhanced holding features. (Figure 1)
- Place the alertcast panel 6 – 8 inches from the curb line. Using a rubber mallet, tap the alertcast panel down flush with the level of the adjacent concrete surface. Note: The embedment process shall not be accomplished by stepping on the panel as this may cause uneven setting which can result in air voids beneath the panel. (Figure 2)
- Place cinder blocks or similar counter-weights on panel to prevent it from “floating” during the curing process. Fifteen minutes after installation re- check the panel to ensure the proper level has been achieved. (Figure 3)
- Once satisfied the alertcast panel installation is per code and project drawings, finish the concrete ramps and walks per project finishing specifications. During the concrete curing stage, avoid standing or walking on the alertcast panel.
- While concrete is workable, create a finished edge expansion joint around the panel perimeter. (Figure 4)
- Once the concrete is cured and ready for pedestrian traffic, remove counter-weights and any protective plastic covering. It may be necessary to cut the plastic covering with a sharp knife.
When properly installed, AlertCast® will provide years of dependable service. Please follow these instructions carefully.
If you have any installation questions or questions about product specifications or warranty, please call us at 1-877-232-6287.
Thank you for your business!
